Proudly Serving the Knoxville Area

Common Problems Requiring Water Heater Repair | Maryville, TN

One of your home’s most important appliances is your water heater. You rely on the hot water it provides almost every day, despite the fact that it may not be visible to the eye at all times. In fact, it is probably rarely or on your mind.

Just because it is out of sight does not mean that it won’t malfunction. In fact, even minor issues can result in significant disruptions. A problem with your water heater can basically put a lot of stress into your home life because you need hot water for everything from cooking, cleaning, taking a shower, and using other appliances. Water heater repair by a local professional in Maryville, TN can take that stress away.

Therefore, it is essential to keep in mind a few of the most prevalent and common causes that can compromise the ability of your water heater to function. The more you know about these common problems, the better equipped you will be when you need to contact a professional for repair or maintenance. Water heater repair is commonly difficult to do yourself and calling a professional Maryville, TN is generally a good idea. Some of the most common problems with water heaters are listed here.

Water Leakage

Leaks emanating from the water heater are probably the most common problem included in this listing. Because water eventually corrodes your tank and causes tiny cracks or fractures, any water heater will eventually begin to leak. However, this does not always indicate that your tank is the source of the leak. If the leak appears to be coming from the top of your tank, then loose water connections could be the cause. This can indicate a problem with the cold water inlet pipes not being securely connected or otherwise loose. If the leak looks like it’s coming from the bottom, then the problem might be condensation, which may suggest a problem with the thermostat. Your pressure relief valve or overflow pipe could also be leaking water. Water heater repair associated with leaks can be a big job and your best bet is to call in a professional.

No Hot Water

Your tank is full of water, but none of it appears to be hot. Your heat source may be the cause of this problem. Your electric water heater’s heating elements may have failed or their electrical connection may have been compromised. There could also be a defective gas connection or a defective pilot light for gas water heaters. If the gas does not ignite despite the pilot light being lit, you may need to repair your burner as a whole. Check your breaker box to see if the water heater’s circuit has tripped. If your heater is more recent, then it may have an electronic ignition system. In each of these cases, calling a local professional knowledgeable in repairs is the way to go.

Strange Odors in the Hot Water

If you turn on the hot water and notice a strange smell, bacteria may have built up in your tank. Any bacteria living in the tank should be killed if the temperature is raised to about 140 degrees Fahrenheit. However, you should avoid using hot water when the temperature is too high because you can be severely burned. Your tank may need to be bleach-cleaned if the issue persists. Alternatively, contacting a local company with expertise in water heater repair is an excellent option.

Water Heats Up Slowly

If your water heater takes a long time to reheat, then several independent issues may be the cause. Your burner may not be functioning well enough to heat your water sufficiently. Also, it is possible that your thermostat is set too low. You could also have issues with your fuel connection system that prevents gas from flowing properly. Water heater repair associated with slow heating issues may require a professional maintenance check.

However, in many instances, the issue with a water heater that takes too long to reheat is simply one of inadequate capacity. It runs out of water and never gets a chance to fully fill up and reheat before it is used again, resulting in lukewarm water flowing through the lines. In this situation, you may wish to have a larger and newer water heater installed.

Low Water Pressure

The smaller, 12-inch plumbing that was the building code for decades is the biggest factor that reduces the water pressure in older homes. The only solution to this issue in an older home is to replace the older narrow pipes with newer pipes of larger diameter. Water heater repair companies can do this job for you.

On the other hand, if your house has modern plumbing, you might be able to boost the pressure of your water by checking to see that the aerators in your sink aren’t clogged, which can happen over time. Also, make sure your water inlet valve hasn’t been accidentally partially closed. Water heater repair necessitated by low water pressure from the heater itself is not an easy do-it-yourself fix.

Inconsistent Heating

Does your heater produce inconsistent water temperatures? This generally indicates that there are issues with your thermostat. To get your thermocouple back to working properly, you may need to have it cleaned or replaced. Water heater repair professionals can do this for you.

If you have excessively cold water, you may have a problem with the energy supply to the unit. Your burner won’t be able to heat the water in your tank enough if the amount of gas flowing through it is too little or not enough for your needs.

Water heater repair generally requires a competent professional to get fixed properly. Are you having problems with your water heater? Perhaps it is time to call in an expert. My Professional Plumber in Maryville, TN has the expertise to fix it!

See our previous blog on this topic here!

Photo By cmannphoto at istock

Location

118 North Peters Road
Knoxville, TN 37923

Hours

Monday–Saturday
8:00 am–5:00pm

CALL NOW