Proudly Serving the Knoxville Area

Problems That Require A Call To A Water Heater Repair Professional | Maryville, TN

You rely on hot water to perform many daily household activities, and life in your home will be challenging without a functioning water heater. The cold water entering the house fills the unit, where it’s heated and stored, so you always have hot water when needed.

Water heater issues can affect the water temperature or your ability to use it. Some problems can result in a flood, so the problem must be addressed as quickly as possible. A DIY repair isn’t recommended because water heaters are complex appliances, and one mistake can cause further issues. Also, if the unit is still under warranty, a DIY repair will void it.

If your unit experiences any of the following problems, it’s best to call a water heater repair professional in Maryville, TN as quickly as possible.

#1 You Don’t Have Hot Water

A lack of hot water is an obvious sign that you may need to call a professional in water heater repair. Before making the call, checking a few things on your end is best to avoid an unnecessary service call. If you have an electric water heater, make sure a circuit hasn’t tripped and there’s power going to the unit. If you have a natural gas-fueled unit, check another gas appliance to ensure your service hasn’t been terminated and there isn’t a widespread outage, and make sure the pilot is lit. Finally, if you have a propane or oil-fueled unit, make sure the pilot is lit, and there is fuel in the tank.

If everything checks out on your end, it’s time to hire a plumber specializing in water heater repair. A lack of hot water often indicates a broken heating element, making it impossible for the stored water to heat up.

If your unit is ten years old, it may have reached the end of its lifespan and can no longer heat the water effectively, and you’ll need to replace the unit.

#2 Lukewarm Water

If the water doesn’t get hotter than lukewarm, check the thermostat. The recommended temperature is between 120 and 140 degrees; if it’s set too low, adjusting the thermostat will solve the problem. You should also consider the temperature outside. If it’s below freezing, the water coming into the house will be very cold, and it will take longer for the water supply to reach the desired temperature.

If everything checks out on your end, it’s time to call a water heater repair professional in Maryville, TN.

The problem could be a faulty thermostat, preventing the unit from receiving the correct signal. If your water heater has two heating elements, one may have failed, and the functional heating element won’t have enough power to heat the water supply.

A plumber can inspect the unit to diagnose the issue and make the necessary repair so that your hot water will be restored.

#3 Strange Sounds

Your water heater should be whisper quiet when it runs, and any strange sound should be checked by a plumber specializing in water heater repair in Maryville, TN.

A banging sound indicates large amounts of sediment buildup in the tank. The sediment will bang the inside of the tank, causing the sound. Ignoring the problem can result in a cracked water tank, so it’s best to address it immediately.

A popping sound indicates sediment buildup at the bottom of the tank. When water gets trapped beneath the sediment, it will boil, causing a popping sound.

A plumber specializing in water heater repair can try to flush the sediment, but if they aren’t successful, you must replace the unit.

#4 Moisture or Fluid Pooling Around the Unit

The area around your water heater should be dry. If there’s moisture on the walls or the unit, there’s likely a cracked, loose, or disconnected hose. Although this is a simple repair, scheduling an appointment for water heater repair is essential. Allowing the problem to persist will result in water damage and mold growth.

Fluid pooling around the unit indicates a leak in the water tank and is very serious. If you don’t have the problem addressed immediately, 50+ gallons of water will flood your home. A leak in the tank cannot be repaired, and the unit must be replaced.

#5 Poor Hot Water Pressure

If your cold water pressure is fine, but the hot water pressure is low, the water heater is responsible. When sediment builds up in the tank, it can clog the waterline, resulting in poor hot water pressure.

A plumber specializing in water heater repair can clear the water line and attempt to flush the sediment. If they can’t, you’ll need to replace the unit because the waterline will continue to clog, requiring multiple service calls, which will add up over time.

The sooner you hire a plumber specializing in water heater repair, the sooner your hot water pressure will be restored.

Call My Professional Plumber Today

If your water heater isn’t working correctly and you need to hire a plumber, look no further than My Professional Plumber. We’re a full-service plumbing company, serving customers in the area for years.

Our plumbers have undergone years of professional training and apprenticeship to learn their craft and have the knowledge and skill to handle any and all plumbing jobs. We want you to feel comfortable allowing our plumbers into your home, so they must pass a background check and drug test before they’re hired.

If you have a plumbing issue that must be addressed immediately, don’t panic. We provide emergency service 24 hours a day, 365 days a year, and we will get a plumber to your house as quickly as possible to resolve the problem.

We’ve earned an excellent reputation in the community and industry over the years, have a 5-star rating on Google, and have won several industry awards. We were Home Advisor’s 2017 Best Of winner and won Cityview’s Best of the Best award in 2018. We also won Angie’s List Super Service Award in 2018 and 2019.

To schedule an appointment for plumbing service, give us a call at My Professional Plumber today.

Photo By Dmytro Varavin at istock

Location

118 North Peters Road
Knoxville, TN 37923

Hours

Monday–Saturday
8:00 am–5:00pm

CALL NOW